Home >

Searching for Euchips, Highlights Kunshan Commercial Street

News

Searching for Euchips, Highlights Kunshan Commercial Street 2018-08-28

Last week, Kunshan Commercial Street opened. Let’s enjoy the charming lighting with Euchips’ EU-BUS system.

Kunshan commercial street was located at Duke Avenue, Zhigu town, Suzhou province; totally 3,000 square meters. The commercial street integrated the lighting designs with life, health, commerce,etc., which was a good representation of landscape lighting with Euchips EU-BUS system.

The lakeside scenery and the ingenious streetscape layout, the elements of the East are integrated into the Western architecture in a new style, the ancient and modern, beautiful and low-key here collide with new life aesthetics and inspiration. The nightscape of Dayuwan depicts beautiful and moving scenery that not only shows the charm of the city, but also promotes the prosperity of the night economy.

At night,  through the faint moonlight, the lighting show will play on weekend or festivals. The commercial street adopted Euchips' EU-BUS system products below:

Relay Switch Controller EUR1220

The product adopts advanced microcomputer control technology, analysis widely used DMX-512 (1990) /RDM,DALI standard protocol, and EU-BUS protocol developed by EUCHIPS, output 12 relay switch signal. The maximum carrying current of each relay switch is 20A,the total 12 channel is 240A.In addition, the device can be connected into the Dynalite system by the Dynalite gateway (Note: the Dynalite trademark holder is PHILPS, the relevant right is owned by the holder of the trademark, the same below)

Features

1. Meets DMX512(1990)/RDM, DALI IEC62386 protocol and EU-BUS protocol developed by EUCHIPS

2. Output 12 channel relay switch signal

3. Built-in LCD, the user can operate more conveniently

4. Set fades time of each channel separately, range of 0.1-60.9s

5. Standard 35 mm din rail, convenient installation

6. Relay switch channel can be turned on or off manually

7. Can save up to 8 events

8. Suitable for intelligent lighting control - Home Furnishing, office buildings, schools, stadiums, outdoor architecture etc.

Leading Edge Controller EUT0802

Leading edge controller is a multi-function triac dimmer Control mode of EUT0802 is flexible, which complies with 4 control protocols:

1, support the international widely adopted DMX-512 (1990) /RDM and DALI standard protocol, and can access to KNX, Dynalite, Lutron, Crestron, LDS and other intelligent dimming network via gateway.

2, support EU-BUS lighting control protocol developed by EUCHIPS. It can be used with relay switch controller, clock module, panel module, sensor module to achieve the group and scene control through the Euchips9 PC software. This solution is widely used in the family, conference rooms, hotels, schools, and other occasions.

3, support Touchdim, manual control, timing control function (optional).The user can manually turn ON/OFF or dim the brightness.

Features

1. Meets DMX512(1990)/RDM,DALI IEC62386 protocol, and EU-BUS protocol developed by EHCHIPS

2. With LCD display and manual button, the user can operate more conveniently

3. In the EU-BUS mode, you can remote update firmware through the EU-BUS interface

4. Output 8 channel phase cut or switch control, max current of each channel is 2A

5. 6.3A fuse delay protection for each 2 outputs

6. Output 12VDC,supply for control system

7. Set fade time of each channel separately, range of 0.1-10s

8. Standard 35 mm din rail, convenient installation

9. Can save up to 8 events(Only for EUT0802-DDLT)

10.suitable for use with TRIAC dimming driver, incandescent, low voltage, etc.

Relay Switch Controller EUR0420


he product adopt advanced microcomputer control technology, analysis widely used DMX-512 (1990) /RDM,DALI standard protocol ,and EU-BUS protocol developed by EUCHIPS, output 4 relay switch signal and their synchronous 0-10V DC control signal. The max current of each channel of relay switch is 20A,the total 4 channel is 80A , the max current of each channel of 0-10V is 20mA.In addition, the device can be connected into the Dynalite system by the Dynalite gateway (Note: the Dynalite trademark holder is PHILPS, the relevant right is owned by the holder of the trademark, the same below)

Features

1. Meets DMX512(1990)/RDM,DALI IEC62386 protocol and EU-BUS protocol developed by EUCHIPS

2. Output 4 channel relay switch signal and their synchronous DC 0-10V control signal

3. Built-in LCD, the user can operate more conveniently

4. Set fades time of each channel separately, range of 0.1-60.9s

5. Standard 35 mm din rail, convenient installation

6. Relay switch channel can be turned on and off manually

7. Can save up to 8 events

8. Suitable for intelligent lighting control - Home Furnishing, office buildings, schools, stadiums, outdoor architecture etc.

EU-BUS To DALI Gateway EUG-DALI


In the EU-BUS system, the user can control the equipment complying with DALI standard protocol via EUG-DALI gateway. The user can assign(including reassign, extent allocation) the address for DALI equipment, and can set group, scene, the switch-on brightness, the minimum brightness, the maximum brightness, fadetime. In addition, the user can know the state of DALI equipment via PC software or information set in advance.

Features

1. Assign(including reassign, extent allocation) the address for DALI equipment

2. In EU-BUS mode, can update firmware remotely via EU-BUS interface

3. Support EU-BUS function to the DALI command

4. Set parameter for DALI equipment, and, can be used with the DALI sensor, DALI panel

5. Support EU-BUS to DALI command function

6. Supplied via EU-BUS bus, without external power supply

7. The standard 35mm din rail, convenient installation